coating thickness

Study on the Influence of Coating Thickness, Mould Structure Type and Rotational Speed on Outside Surface Quality of Centrifugal Casting Ductile Iron Pipes by Heated Mould Method

铸型类型及其转速和涂料层厚度对热型法离心铸造球铁管外表面质量影响的试验研究

Spraying equipment along with roller axial movement speed determines the roller surface coating thickness.

喷涂装置沿辊筒轴向移动的速度决定了辊筒表面获得的涂布厚度.

The back of the coating thickness according to need.

不面后涂层的厚度可根据需给.

Books and periodicals on the cohesion and effectiveness of resin content, gummed coating thickness and grooving.

书刊的黏结效果与上胶量 、 背胶的涂布厚度及开槽大小有关.

A Coating Thickness Measurement System Based on Fringing Electric Field Sensor

基于边缘电场传感器的涂层厚度检测系统

Results show that thermal fatigue behavior is associated with circle temperature and coating thickness.

结果表明,复合涂层的热疲劳行为与热循环上限温度、涂层厚度有关.

Some poor quality aluminum plates to hide version based on the photoptic rubber coating thickness.

有些劣质版材为了包藏铝版底基上的砂纲,不兵感平胶膜层的厚度增不小.

The influence of the coating thickness on the waveform is analyzed.

该方法为透明薄膜/基底系统的定量检测和无损评价提供了理论依据.

Coating thickness measurement control depends on the speed of the gap and roller.

涂层厚度的控制就取决于计量辊的间隙和辊筒的转速等因素.

The mathematics model that showed photoresist spin coating thickness evolvement on spherical surface was put forward.

提出了球面旋涂微米级厚度光刻胶膜层薄化率公式及径向位置演变公式,并得到了膜厚分布的演变公式.

Coating Thickness Distribution of an Arc and its Simulation Based on The New Model of Spray Gun

基于喷炬新模型的圆弧面涂层厚度分布及仿真研究

The results show that in the initial stage of micro-arc oxidation the obtained ceramic coating is compact and nearly no microflaw can be observed, the microflaws like holes begin to appear in the exterior and finally irregular holes fill with 90% of the thickness range.

结果表明：微弧氧化初期，陶瓷层致密，几乎观察不到显微缺陷，随着处理时间的延长及陶瓷层的增厚，其外侧开始出现孔洞类缺陷，直至90%厚度范围布满相互交错的不规则孔洞；

On the viscosity on coating thickness has a great impact, on a low viscosity, overlay thin.

上光油的黏度对涂层厚度有着较大的影响, 上光油的黏度低, 涂布层薄.

Establish the better thickness range of film coating;

确定薄膜衣层的最佳厚度范围；